15000 service

[TommyXP]

I am most probably certain that you will be most happy with yourself IF while your in there you throw some new rollers in.
I promise you, they will be anything but perfectly round and you will notice a BIG difference on your next ride.

[jackfrank]

Thanks....will also replace the 'ramp plate sliders' and try to have the pulley and belt in the proper grooves and shoulders before tightening.
Also, is SHS a honda scooter service? The internet doesn't seem to recognize it.

never knew there was so much engineering in such an inexpensive vehicle. Now I know why the belt doesn't drive the rear wheel directly, the clutch is there is one reason.

Here ya go.
https://shspowersports.com/

First thing, use the variator tool to remove the clutch bell. Check inside it to see if there is grease in it ,if not, your seals are good. Mine had a bad judder on accelerating from a stop at 22,000 miles. Thought it was the clutch but it was the rear pulley bearings and seals.

(1)COLLAR, SEAL
23237-KGF-910

(1)BEARING, NEEDLE (22X29X18)
91002-KFG-003

(1)BEARING, RADIAL BALL (6902U) (FUJIKOSHI)
91002-GA7-701

(2) SEAL, DRIVEN FACE (34X41X4)
91211-KN7-671

(2) O-RING (38.8X1.9)
91384-KRJ-901
These are the parts I replaced. I was able to make a spring compressor and I bought a socket. SHS should charge 1 hour labor to do this for you. I had them replace the water pump seals for me and they did a damn good job.

Thanks for sharing a beautiful link. Here all parts are available.
Thanks